The Drawer Problem

 This is the thickness of the drawer wall.  I tried to spin it around but ... well...

This is the inside of the drawer.  Note the multiple holes.

The front of the drawer with the two little screw ends sticking out.

Poor little screw heads.  Maybe a centimetre of grabbing power.

This is the the thickness of the front panel.  It is beveled on the front.

The back of the panel.  Multiple holes and remnants of the failed wood filler experiment.

Here's a close up.  Wood has left the building!

Here's what one of the good drawers looks like inside.

Here's a shot showing the warp in the wood.  The board is laying flat on the counter.  That's a nickel next to it.  I would guess that you could put a nickel under each side and the middle of the panel would still touch the counter.  The warp is different through the entire board.